Motorists Need To Prepare For More Highway 260 Blasting Work

Advertisement

The Arizona Department of Transportation (ADOT) will close a two-mile segment of State Route 260 15 miles east of Payson for about an hour beginning at 10 a.m. on Tuesday (July 20).

Eastbound traffic will be stopped at approximately milepost 265, and westbound traffic will be stopped at approximately milepost 267.

The roadway will be closed while workers blast and clear material to provide room to widen the highway. ADOT advises drivers to plan ahead to drive through the work zone before 2 p.m. or after 3 p.m. to avoid delays.

Drivers should allow extra time to reach their destinations. Speed limits are reduced and a width restriction of 10 feet is in place. Message boards, temporary barricades and signage will guide motorists through the work zone.

ADOT advises drivers to slow down, be alert for workers and heavy equipment, and anticipate delays as construction continues until fall 2011.

Comments

Use the comment form below to begin a discussion about this content.

Requires free registration

Posting comments requires a free account and verification.